3D Printing Stack Exchange
3D Printing Stack Exchange

Questions tagged [anycubic-photon]

5 questions
1
vote
0 answers

How to fixcrack from a print pause?

I was printing a leather mold on my Anycubic Photon Mono 4k. I needed to pause the print to refill resin vat, and at the height of the pause I got a crack. Resin is washed, but not yet cured. So how do I go from here? I don't want to have to reprint…
Mołot
  • 801
  • 4
  • 14
1
vote
2 answers

Equipment for starting with SLA printing

I am completely new to 3D printing and want to start with SLA printing. I found the Anycubic Photon Mono 2 printer, but on the ordering page, there are options for "Airpure" and "Wash & Cure" machines. I do not know what these are, nor if they are…
user1584421
  • 123
  • 4
1
vote
1 answer

What could cause delamination in the raft?

I got a brand new Anycubic Photon Mono 4k about a week ago. Printer is new, FEP is clean, it was a fresh load of Anycubic Standard+ resin. I got a couple of good prints, including perfect Cones of Calibration, miniatures etc, just things you print…
Mołot
  • 801
  • 4
  • 14
1
vote
1 answer

Resin forming thin layer on bottom of vat (sludgelike)

I have just bought the Anycubic Photon Mono X and I am having some trouble. I was wondering if anyone else ever had this issue. The resin seems to be hardening on the bottom of the vat after I cleaned it and tried to do a print. This sometimes…
Cody Luukkonen
  • 11
  • 3
0
votes
1 answer

Resin printer adds a small block along the far right side

My Photon Mono 4k adds a small block along the right side and no matter what I do, it still makes it. It doesn't stop it from printing but is wasting a good bit of resin. Does anybody have an idea as to what's happening?
Yoxi
  • 1