Questions tagged [reset]
4 questions
3
votes
2 answers
M502 will reset all configurable settings to their "factory defaults", which settings are those?
From the M502 documentation page can be read that M502:
Reset all configurable settings to their factory defaults.
Please note that this phrasing from the manual has been used in the question title!
To also reset settings in EEPROM, follow with…

0scar
- 35,554
- 12
- 65
- 151
1
vote
0 answers
Ender-3 Pro Factory reset/BLTouch Setup
I bought the BLTouch and followed the instructions to install it, but it ended up not working. After installing the new firmware, the screen started bugging out (pixels being out of place, always moving). And when I tried to use the BLTouch, it…

BobbyWasbi8311
- 11
- 1
0
votes
1 answer
Error message "homing failed printer halted please reset"
I have an Ender 3 Pro 4.2.7 2.0.8.2 that I haven't used for a couple of months; switched it on, all perfect. I tried to print a model and the PLA wouldn't stick to the bed; I think the hotend was a fraction high.
Re-adjusted bed to ensure square…

Laserman_UK
- 11
- 1
0
votes
1 answer
Factory reset needed!
I have just bought a Creality Ender 3 Pro. During setup, I think I must have applied an offset... The nozzle lifts up about 5 mm from the bed when starting to print.
I am reading that M502 resets to factory settings and M500 saves the settings. I…

Barry Windsor
- 1
- 1
- 1
- 2