3D Printing Stack Exchange
3D Printing Stack Exchange

Questions tagged [tronxy]

For general questions related to Tronxy printers or the manufacturer Shenzhen Tronxy Technology Co., Ltd.

For general questions related to Tronxy printers manufactured by Shenzhen Tronxy Technology Co., Ltd.

If the model is known then please use the appropriate tronxy+<model name> tag.

6 questions
3
votes
2 answers

Why are the options for PID control commented out in Klipper config file?

I have a Tronxy VEHO-600 I'm currently vamping up with Klipper. I have a config file I got from a friend for a modified VEHO-600. My question is regarding the heater bed code block seen below: [heater_bed] heater_pin: PE2 sensor_type: EPCOS 100K…
General raid
  • 129
  • 4
3
votes
2 answers

Tronxy Marlin boards (two of them) reboot when asked to heat bed

I have two Tronxy 2.0 V5 Marlin boards that reboot whenever heat is applied to the bed. The bed has been swapped (because I thought that was the problem) for a new shiny one. The thermistors, too, of course. The same boards (both) work when the…
Peltier Cooler
  • 63
  • 6
2
votes
1 answer

TronXY X5S system (Marlin) - Very Slow menus

This is my board MKS Melzi v2.0 cloned I replaced the MCU (the actual IC) with new ATmega1284P 16 MHz, because the old MCU was damaged - the reason was that the fan got dusty and the power line became unstable. I replaced the MCU with the exact…
ioen jid
  • 43
  • 5
1
vote
0 answers

looking for help setting up stepper motor code blocks in klipper printer.cfg file

the machine in question is a tronxy veho 600. i have obtained a printer.cfg file for a highly modified veho 600 but my one is standard bar the cr touch i have yet to install. the reason for this post is to understand why some of the setting in the…
General raid
  • 129
  • 4
1
vote
0 answers

seeking out help writing a printer.cfg klipper file for a tronxy veho 600

i recently took delivery of a tronxy veho 600, i found the standard firmware to be a major bottleneck so with the help of a raspberry pi 4b and a cr touch i am making some upgrades. unfortunately there is little to no info regarding the printer.cfg…
General raid
  • 129
  • 4
1
vote
1 answer

Marlin firmware 2.0.9.1 for X5SA example : MM_PER_ARC_SEGMENT Compilation Error

I have a Tronxy X5SA printer upon which I want to install the latest Marlin firmware v2.0.9.1. I take the configuration example on GitHub for the X5SA printer and modify the lines in configuration.h as recommended in the guide (see this URL). In…
Julo0sS
  • 121
  • 5