3D Printing Stack Exchange
3D Printing Stack Exchange

Questions tagged [jyers]

6 questions
4
votes
1 answer

Inconsistent Z-height on Ender 3 V2 print bed

I have an Ender 3V2 running a custom version of Jyers Marlin, and using a CR Touch as a Z-stop, and with a heated glass print bed. This is my first printer, and it mostly prints fine except when printing near the edges where some imperfections with…
jasooney23
  • 71
  • 7
3
votes
1 answer

Browsing and printing print files (G-code) stored in OctoPrint from printer's screen

I'm using an Ender 3 v2 with Jyers firmware. I'm looking for a firmware / OctoPrint plugin which allows browsing G-codes stored in my OctoPrint storage and starting them directly from my printer's screen like it's stored on SD card. I would like to…
Piotr Smarzyński
  • 33
  • 2
3
votes
2 answers

Extruder stops printing before finishing first layer (Ender 3 v2 w/BIQU H2)

Let me preface this with me being quite a newbie to 3D printing, however, I am an engineer and coder, so tinkering with stuff like this is quite the norm for me. Don't be afraid to be too technical, knowledge is power! I recently purchased a new…
user995551
  • 228
  • 3
  • 7
3
votes
1 answer

What would cause magic smoke with a BLTouch installed?

I decided to purchase a BLTouch for my Ender 3 V2. I did all the physical installation of the BLTouch at the same time as adding LED lighting. I plugged in the power to test the lighting (BLTouch was not plugged in yet) and everything came on fine…
agarza
  • 1,559
  • 2
  • 15
  • 33
1
vote
0 answers

Creality Ender 3 V2 Printed objects incorrect dimensions

I have had a Creality Ender 3 v2 with a 4.2.2 motherboard for about 2 years. It's a company-owned machine but I got it just about when Covid hit so it has only been used at home. It worked OK at first. I used it a good bit. Then I got a Prusa and…
Chuck
  • 11
  • 2
0
votes
0 answers

Ender 3 V2 & BLTouch with Jyers firmware not compensating

I got the Jyers firmware to upgrade my Ender 3 V2 and added a BLTouch. I got it up and running, followed most of the tutorials on the internet and videos, and uncommented all that was needed. The BLTouch is doing its work creating the mesh values,…
Eduardo Elias
  • 131
  • 1
  • 4