Questions tagged [resonance-compensation]
3 questions
1
vote
1 answer
Does an accelerometer in a Marlin-based Input Shaping setup compensate in real-time (during print) for vibration?
In addition to my question How to physically wire a (ADXL345) accelerometer for Input Shaping (Resonance Compensation) support on for a Ender 3 V2 printer?.
Does an accelerometer in a Marlin-based Input Shaping setup compensate in real-time (during…
Bob Ortiz
- 1,053
- 1
- 3
- 29
1
vote
1 answer
How to physically wire a (ADXL345) accelerometer for Input Shaping (Resonance Compensation) support on for a Ender 3 V2 printer?
I'm looking into Input Shaping (Resonance Compensation) to compensate for vibration on an Ender 3 V2. I found the "Official Creality G-Sensor ADXL345 Vibration Compensation Sensor for Sonic Pad 3D Printed Smart Pad" which I guess, unlike the name…
Bob Ortiz
- 1,053
- 1
- 3
- 29
0
votes
1 answer
Does Marlin input shaping compensate vibration on all X, Y and Z axes?
The Marlin Firmware supports Input Shaping (M593) as described in the Marlin documentation writing:
Set the Input Shaping damping factor and/or frequency (in Hertz) for axes that support it.
But the parameters shown under the Usage section suggest…
Bob Ortiz
- 1,053
- 1
- 3
- 29